Velocidade da placa de rede no linux

Por vezes precisamos verificar a velocidade estabelecida pela placa de rede, verificar se estamos fechando um link de gigabit com switch por exemplo, ou identificar a interface deixando-a piscando ( -S ), etc.

#ethtool enp5s0

Settings for enp5s0:
Supported ports: [ TP MII ]
Supported link modes:   10baseT/Half 10baseT/Full 
                        100baseT/Half 100baseT/Full 
                        1000baseT/Half 1000baseT/Full 
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes:  10baseT/Half 10baseT/Full 
                        100baseT/Half 100baseT/Full 
                        1000baseT/Half 1000baseT/Full 
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Link partner advertised link modes:  10baseT/Half 10baseT/Full 
                                     100baseT/Half 100baseT/Full 
Link partner advertised pause frame use: Symmetric Receive-only
Link partner advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Cannot get wake-on-lan settings: Operation not permitted
Current message level: 0x00000033 (51)
       drv probe ifdown ifup

Link detected: yes

Postagens mais visitadas